AAOK

 

Learn More

Alloy Picatinny/Weaver RAIL GAS TUBE fits most AK models with Vented Gas Tube. Clamps directly to barrel for maximum stability, accuracy, and optimum bore alignment. Solid, one-piece 6061-T6 hard anodized aluminum body. Comes with 4140 steel clamps, screws, allen wrench, and instructions. Only minor gunsmith skills needed to install. Made in U.S.A. Learn More

Alloy Picatinny/Weaver RAIL GAS TUBE fits Hungarian AK models - SHORT 5 7/8" long. Clamps directly to barrel for maximum stability, accuracy, and optimum bore alignment. Solid, one-piece 6061-T6 hard anodized aluminum body. Comes with 4140 steel clamps, screws, allen wrench, and instructions. Only minor gunsmith skills needed to install. Made in U.S.A. Learn More

Alloy Picatinny/Weaver RAIL GAS TUBE fits YUGO AK models - 7 1/2" long. Clamps directly to barrel for maximum stability, accuracy, and optimum bore alignment. Solid, one-piece 6061-T6 hard anodized aluminum body. Comes with 4140 steel clamps, screws, allen wrench, and instructions. Only minor gunsmith skills needed to install. Made in U.S.A. Learn More

Some AK barrels have a smaller diameter at clamping point of about .600". This shim set brings the diameter up to the normal .700" barrel diameter needed for mounting our RAIL GAS TUBE properly. Learn More

This RAIL LOWER HANDGUARD fits all STAMPED RECEIVER AK Models and is Made in the USA machined from high strength Mil Spec Hard Anodized Aluminum with 4140 steel attach points. Comes with mounting hardware and instructions. The Picatinny/Weaver Rails give plenty of room for your hand, plus any combination of rail mount lights, lasers, grips, sling mounts, bipod mounts, etc. This "Compact" 8 5/8"long version is shorter than our other models, but is still longer than the original AK handguard. The special expanding rear tension system squares and centers itself firmly inside the receiver. The dual, floating clamp system in front locks the unit to the barrel without applying off-axis forces that could affect accuracy. You can mount a quality laser aiming module with full confidence in maintaining your zero under harsh field conditions. A result of this thoughtfully engineering Handguard is increased cooling efficiency of the rifle, plus lightweight, strong, comfortable, stable and versatile rail mounting. This RAIL HANDGUARD fits over the outside of the original forend cap (covering the forend cap mounted sling loop - but sling loops mounted at the gas block are still available for use) and has enough width that your rail mounted items will be far less likely to interfere with one another. Shown installed with optional accessories which are sold separately. Learn More

Same Specs as our UM-6, but fitted for MILLED RECEIVER AK Models. Learn More

Same Specs as our Compact version for STAMPED AK Receivers, but 1" longer at 9 5/8". Learn More

Same Specs as our UM-8 Standard Length RAIL LOWER HANDGUARD, but machined to fit MILLED AK Receivers. Learn More

 

Learn More